The new interface can also handle the new CAN FD standard with its reconfigurable FPGA hardware architecture. In the interplay of the new device with the Vector tools CANoe.AFDX or CANalyzer.AFDX, it is now possible to access the Ethernet-based AFDX protocol that is widely used in the aerospace industry. In what is known as Ethernet monitoring, the new interface offers a transparent connection (in/out/monitor) between two nodes with precise time stamps. The advantage here is that the user can connect existing standard Ethernet loggers and accessories when used as an Ethernet media converter.

While two high-speed CAN channels are available in the CAN section, the Ethernet section supports Broad-R-Reach and standard Ethernet IEEE 802.3 (100BASE-TX or 1000BASE-T). The bus interface has two separate channels for Ethernet and CAN, which enables simultaneous operation of a remaining bus simulation with the CANoe.IP or CANalyzer.IP Vector tools. According to the supplier, in particular developers will benefit from precise time stamps with a common time base for synchronizing the various systems. Automotive Diagnostic Tool Cable INPA K + DCAN USB OBD2 Interface FT232RQ Chip for BMW E60 E83. The new hardware can be used in tasks ranging from remaining bus simulations to Ethernet monitoring and synchronization of Ethernet frames with other bus systems such as CAN. Developers in the automotive and aerospace industries are supposed to benefit from simultaneous access to CAN networks and Ethernet-based systems such as Broad-R-Reach or AFDX with one interface.

Vector introduces the new VN5610 device - a compact Ethernet/CAN interface with USB. A Controller Area Network (CAN bus) is a robust vehicle bus standard designed to allow microcontrollers and devices to communicate with each others. I have never heard of a switch-mode K+DCAN interface - I assume the reasons being that on DCAN cars one pin is used for a ethernet connection and the other to tha K data line - on K line cars, both pins are connected to K data lines and that creating a switch mode circuit would cost more than the interface is worth.

Dcan interface